Displaybacklight; Mode; Hold/Flashlight - koban KMD-16 Manual Del Usuario

KMD-16
TRMS Multimeter
Note:ManualrangingdoesnotapplyfortheCapacitanceandFrequencyfunctions.
6.1 MAX/MIN
Note:WhenusingtheMAX/MINfunctioninAutorangingmode,themeterwill"lock" into the range that is displayed on the LCD
when MAX/MIN is activated. If a MAX/MIN reading exceeds that range, an "OL" will be displayed. Select the desired
range BEFORE entering MAX/MIN mode.
1. Press the MAX/MIN key to activate the MAX/MIN recording mode. The display icon "MAX" will appear. The meter
will display and hold the maximum reading and will update only when a new "MAX" occurs.
2. Press the MAX/MIN key again and the display icon MIN will appear. The meter will display and hold the minimum
reading and will update only when a new "MIN" occurs.
3. To exit MAX/MIN mode press and hold the MAX/MIN key for 2 seconds.

6.2 Displaybacklight

Positive Display and Backlight on when unit is turned on

6.3 MODE

Press MODE key the selection of double measured functions which are present at display is possible. In particular this key is
active in
current position to select between AC or DC current measurements.

6.4 HOLD/FLASHLIGHT

The hold function freezes the reading in the display. Press the HOLD key momentarily to activate or to exit the HOLD
function.
Press the HOLD key for >1 second to turn on or off the FLASH light function.
The flash light and will automatically power OFF after 5 minutes of inactivity.
102
position to select among resistance test, diode test, continuity test and capacitance test, and in
www.grupotemper.com