Electric Handle Heating; Information Before You Start - Stihl MS 460 Manual De Instrucciones

English / USA
Bei angebauter Abdeckplatte muss der
Schieber in Winterstellung im
Vergaserkastendeckel sitzen.
:
Bei stark abgekühlter Motorsäge
(Reifbildung) – nach dem Starten
den Motor unter erhöhter Leerlauf-
drehzahl (Kettenbremse lösen!) auf
Betriebstemperatur bringen
Bei auftretenden Motorstörungen
zunächst die Notwendigkeit des
Einsatzes der Ansaugluft-Vorwärmung
prüfen
34
Electric Handle
Heating*
Switching on electric handle heating*
:
Move switch on front handle to I –
move switch back to 0 to switch off
the heating.
There is no risk of overheating during
long periods of operation. The whole
heating system is maintenance-free.
* see "Guide to Using this Manual"
Information
Before You Start
STOP
0
The four positions of the
Master Control lever
0
= Engine off –
ignition is switched off.
# # # # = Normal run position –
engine runs or can fire.
To move the Master Control lever from # # # #
n l
to or , press down the throttle
trigger interlock and squeeze throttle
trigger at the same time.
n n
n n
=Warm start – this position is used to
start a warm engine. The Master
Control lever moves to the normal
run position as soon as the throttle
trigger is squeezed.
l l l l
=Cold start – this position is used to
start a cold engine.
MS 460, MS 460 R