Condenser Filter Cleaning; Power Failure / Vacation Time; Vacation Time - Avanti IMC132A3S Manual De Instrucciones

NOTE:
THE BACK SIDE OF THE ICE MAKING MOULD MUST BE
CLEANED BY A PROFESSIONAL.
Sanitizing the Ice-Making System
1. Turn off power to the ice maker.
2. Remove all ice cubes from the storage bin.
3. Prepare a sanitizing solution made of 1 ounce of household bleach and 2 gallons of hot water
95ºF (35ºC) to115ºF (46 ºC).
4. Fill a spray bottle with the sanitizing solution and spray all corners and edges, making sure to
cover all surfaces with the solution. Rinse with clean water.
5. Keep the ice maker connected to the water supply. Turn on the power to the ice maker.
Within 5 minutes, press the CLEAN button. The machine will run the Automatic Clean mode.
6. Allow 30 minutes for proper cleaning.
7. The unit will begin the automatic ice making process when the clean cycle is complete.
8. Discard the first batch of ice.

Condenser filter cleaning

A dirty or clogged condenser prevents proper airflow, reduces ice making capacity, and causes higher
than recommended operating temperatures that may lead to component failure. Have the condenser
cleaned at least once every six months.
1. Turn the Power Switch to the OFF position.
2. Unplug the ice maker or disconnect power.
3. Gently pull out the front louver filter.
4. Remove dirt and lint from the filter with the brush attachment of a vacuum cleaner.
5. Reinsert the front louver filter.
6. Plug in the ice maker and turn the power switch to the ON position.
Power Failure
Most power failures are corrected within a few hours and should not affect the temperature of your
icemaker if you minimize the number of times the door is opened. If the power is going to be off for a
longer period of time, you need to take the proper steps to protect your food.

Vacation Time

Short vacations: Leave the unit operating during vacations of less than three weeks.
Long vacations: If the icemaker will not be used for several months, remove all ice cubes, drain then
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly: blocking it open if necessary
15