Installation Of Your Icemaker; Installation Clearances - Avanti IMC132A3S Manual De Instrucciones

Installation of Your Icemaker

·
THIS ICEMAKER MUST BE PROPERLY INSTALLED BY A QUALIFIED PROFESSIONAL
This icemaker SHOULD be installed with electrical and water connections in accordance
with all state and local codes.
·
Place your icemaker on a floor that is strong enough to support the icemaker when it is fully
loaded. To level your icemaker, adjust the legs at the front of the icemaker.
·
Allow a minimum of ¾ inch of space between the top and 3 inches at the sides of the
icemaker and a minimum of 5 inches at the back, which allows the proper air circulation to
cool the compressor. Ensure the front of the unit is completely unobstructed.
·
Locate the icemaker away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the icemaker not to perform
properly.
·
Choose a well ventilated area with temperatures above 50ºF (10ºC) and below 110ºF (43ºC).
This unit MUST be installed in an area protected from the elements.
Allow a minimum of 3 inch of space between the sides, ¾" at the top of the icemaker and
a minimum of 5 inches at the back, which allows the proper air circulation to cool the
compressor. Ensure the front of the unit is completely unobstructed.
• The installation of this icemaker requires a cold water supply inlet of ¼" (6.35mm) soft copper tubing
with a shut off valve.
• The icemaker requires a continuous water supply with a minimum pressure of 14.5 psig and a static
pressure not to exceed 80 psig. The temperature of the water supply into the icemaker should be
between 41ºF (5ºC) and 77ºF (25ºC) for proper operation.
• It is strongly recommended that a water filter be used. A filter, if it is of the proper type, can remove
taste and odors as well as particles. Some water is very hard, and softened water may result in
white, mushy cubes that stick together. De-Ionized water is NOT recommended.
Warning

INSTALLATION CLEARANCES:

Operation of the icemaker for extended periods outside of the normal
temperature ranges as described above may affect product performance.
9