Operating Your Icemaker; Operating Method - Avanti IMC132A3S Manual De Instrucciones

Description of LEDs and buttons:
1. Ice Bin Full LED: Bin full indicator light
When it is lit, the ice storage bin is full of ice or there is something blocking the bin-full probe. The
unit will stop working. When ice cubes are removed from the ice storage bin, freeing the bin-full
probe, the LED will turn off and then the unit will restart and return to the ice making mode.
2. Ice Making LED: Ice making indicator light
When it is lit, the unit is working in the ice making mode controlled by a temperature probe on the
evaporator.
3. Clean button: When this button is pressed, the unit enters the "CLEANING" mode. The Clean
system will run through a full clean of the water system and Evaporator. The water used during
the clean mode will drain through the drain hose. Once the clean system is complete, it will return
to normal operation automatically.
4. Timer Reset: This button is to reset the "Clean Filter" reminder. After approximately 350 hours of
compressor runs or ice-making cycles, the unit will emit a beep and all (3) three indicator lights will
flash (Power, Ice-Making, Ice-Full) to remind you to clean the condenser filter at the front of the
unit. Once you have removed the filter, cleaned it and returned it to its original place. Press the
"Timer Reset" button to reset the reminder.

Operating method

Turn on the water tap, let the water trough fill, then press the ON/OFF button on the front
panel. The ice maker will start working automatically.
1.
After 3 minutes, the machine will automatically go to the ice-making stage, and the sound of water
flowing will be heard.
3. When the batch of ice has been fully formed, ice will automatically be harvested to the ice storage
bin.
4. When the ice storage bin is full, the machine stops making ice automatically.
5. The unit will start making ice again after the ice cubes are removed.
IMPORTANT:
·
Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of cubes must be discarded.
·
Never turn the water supply tap off when the ice maker is working.
·
Never touch the evaporator when unit is running!
·
Except to take ice from the unit, keep the door closed to reduce melting and insure proper ice
formation.

OPERATING YOUR ICEMAKER

12