To Operate The Product In A Tree; To Remove A Trapped Product - Husqvarna T525 Manual Del Usuario

2. Use approved carabiners to attach the free end of
the safety strop to one of the connection points on
the harness. This is your primary connection point.
CAUTION: The safety strop must only be
attached to the rope eyelet.
3. Make sure that you are in a stable and safe position
to make the cut.
4. Release the product from the secondary connection
point, start the product and make the cut.
5. Engage the chain brake directly after the cut is
completed.
6. Stop the product and put it in its secondary
connection point.

To operate the product in a tree

WARNING: Most accidents occur when the
operator does not have full control of the
product or the work position.
• Keep a safe work position.
• Cut horizontal sections at hip level and vertical
sections at solar plexus level.
• Hold the product with 2 hands.
• Make sure that you are stable on your feet and keep
a low lateral force when you cut vertical branches.
Steer the safety line through a different connection
point to remove or prevent increasing lateral forces.
You can also use an adjustable strop directly from
the harness to a different connection point.
16
• Use a foot loop to keep a safe work position.
• Do a check of the harness, belt and ropes at a
regular interval.
• If you must climb with the product, attach the product
to the rear connection point on the harness. The rear
connection point keeps the product clear from
climbing lines and makes sure that the weight has
central support down your spine.
WARNING: You must engage the chain
brake when you lower the product onto
its strop.

To remove a trapped product

1. Stop the product.
2. Attach the product safely to the tree inboard, against
the trunk side, of the cut or a different tool line.
3. Carefully pull the saw away from the kerf while you
lift the branch as necessary.
WARNING: Do not try to pull the product
free. Risk of serious injury.
4. If it is necessary, use a hand saw or a second
chainsaw to release the product. Cut the branch at a
minimum of 30 cm/12 in from the caught product.
Make the cut on the outer end from where the
product is caught.
732 - 017 - 11.10.2019