To Adjust The Seat; To Engage And Disengage The Drive System; To Adjust Height Of The Steering Wheel - Husqvarna R 322TX AWD Manual Del Usuario

Ocultar thumbs Ver también para R 322TX AWD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
Do a check of the fuel level before each use and
refuel if necessary.
Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.

To adjust the seat

WARNING: Do not adjust the seat during
operation of the product.
1. To adjust the seat forward and rearward, put your
feet on the footrest plates.
2. Push the lever below the front edge of the seat, to
the side.
3. Move the seat to the position that is correct for you.
4. To adjust the seat springs, move the 2 rubber stops
below the seat as given in the illustration. Put the 2
rubber stops in the front, middle or rear holes below
the seat.

To adjust height of the steering wheel

WARNING: Do not adjust the height of the
steering wheel during operation of the
product.
849 - 004 - 21.10.2019
1. Turn the knob counterclockwise to loosen.
2. Adjust the height of the steering wheel.
3. Turn the knob clockwise to tighten.
CAUTION: Make sure that the long end of
the knob points up.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The product has one drive system lever for the front axle
and one for the rear axle. The drive system lever for the
rear axle is found behind the left rear wheel.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido