To Adjust The Seat; To Engage And Disengage The Drive System; To Adjust Height Of The Steering Wheel - Husqvarna R 316TX Manual De Usuario

• Do a check of the fuel level before each use and
refuel if it is necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.

To adjust the seat

WARNING:
during operation of the product.
1. To adjust the seat forward and rearward, put your
feet on the footrest plates.
2. Push the lever below the front edge of the seat up
and move the seat to the correct position.
3. To adjust the seat springs, move the 2 rubber stops
below the seat as given in the illustration. Put the 2
rubber stops in the front, middle or rear holes below
the seat.

To adjust height of the steering wheel

WARNING:
the steering wheel during operation of the
product.
844 - 009 - 25.11.2021
Do not adjust the seat
Do not adjust the height of
1. Turn the knob counterclockwise to loosen.
2. Adjust the height of the steering wheel.
3. Turn the knob clockwise to tighten.
CAUTION:
of the knob points up.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever for model R 316TX is found
behind the left rear wheel. Model R 316TX AWD, R
316TsX AWD has one drive system lever for the front
and one for the rear axle. The drive system lever for the
rear axle is found behind the left rear wheel.
Make sure that the long end
15