Würth Modulares System Instrucciones De Montaje página 16

Floating floor attachment (Fig. II)
No. Description
1
ORSYmobil component
2
Screw DIN 912 M8x16
3
Pane or square plate
4
Würth Multiplex wooden base
5
Vehicle floor sheeting
6
Drive-in nuts M8 x 11 x 32
Perforated floor attachment (Fig. III)
No. Description
1
ORSYmobil component
2
Screw DIN 912
3
Pane or square plate
4
Würth Multiplex wooden base
5
Vehicle floor sheeting
6
K-disc d=40mm
7
Nut M8 DIN 985, self-locking
8
Raised beading in vehicle floor sheeting
Side panel attachments on open vehi-
cle bars (Fig. V)
No. Description
1
Attachment bracket
2
Screw DIN 912 M8 x 20
3
K-disc d = 24 mm
4
Attachment plate with nut (riveted)
5
Screw DIN 912 M8 x 30
6
Rubber washer 30 x 7 mm
Side panel attachment on closed vehi-
cle bars (Fig.VI)
No. Description
1
Rubber washer 30 x 7 mm
2
Nut M8 DIN 985, self-locking
3
Bend K-disc d = 24 mm upwards on left
and right
4
K-disc d = 24 mm
5
Screw DIN 912 M8 x 20
6
Attachment bracket
7
Riveting nut M8
16
Assembly
Check that the delivery scope is com-
plete and undamaged.
We would like to indicate that, due to the production
tolerances of the vehicle manufacturer, the dimen-
sions of the plate may deviate by up to 20 mm and
may require rework. This applies specifically to
vehicles equipped with serial boot lining as well as
for station wagons.
Assembling the vehicle floor
Direction of travel
Place the individual or multi-part multiplex base
■
plate into the vehicle with the structured side
pointed up.
Assemble individual parts with the groove and
■
tongue connection.
If the vehicle equipment is not screwed
to the vehicle floor, observe information
in the provided assembly set instruc-
tions!