General Information - Würth Modulares System Instrucciones De Montaje

GB
Thank you for choosing vehicle equipment from Würth. Your new, high-quality equipment
was crash-tested in conformity with the ECE R17 guideline. Please assemble this equipment
according to these instructions.
We recommend that you always have your vehicle equipment assembled by one of our
installation partners or specialised company.
These instructions are generalised and are intended to help you not only in the assembly
but also during daily use. We wish you much joy in the daily use of your new vehicle
equipment.
Keep the vehicle's centre of gravity as low as possible.
■
Consider load distribution, with heavy parts at the bottom.
■
Observe the permitted total weight, or the axle loads respectively.
■
We recommend the installation of a partition to the driver's cab.
■
Secure loose parts and apply load safety elements.
■
Check that the delivery scope is complete and undamaged.
■
Number of attachment points "Wall"
Module height
≤ 950 mm
950 - 1,160 mm
1,160 - 1,430 mm
> 1,430 mm
The respective number
increases when using
riveting nuts!
Assembly Instructions

General Information

Attachment points
"Front" area
1
2
2
3
Attachment points
"Rear" area
"Front"
2
2
3
3
"Rear"
15