Art. 0963 80 525 - Würth Modulares System Instrucciones De Montaje

When using drive-in nuts, the base plate must be
■
removed for work.
Observe tightening torques!
■
Remove chippings, shavings, etc.!
■
Perforated floor attachment (Fig. III)

Art. 0963 80 525

Quantity Description
4
4
4
4
4
Attention
Drilling through vehicle bars and sheet
metal poses an increased risk of injury
on sharp edges and rims! Ensure that
cables, lines or liquid containers remain
undamaged!
Apply corrosion protection in accordance
with manufacturer specifications!
We recommend Würth Underbody Protection
Art. 0892078.
Remove chippings, shavings, etc.!
We would like to point out that vehicle
equipment not mounted to base plates
may invalidate the vehicle's warranty.
Please contact your manufacturer to
clarify this issue.
18
(Self-locking) M 8
Hexagonal nut
Allen screw M 8 x 40
Allen screw M8 x 50
Washer Ø 18
Reinforcement 55 x 24.5
plate
Mounting on side panels
Side panel attachments on open vehicle
bars
Art. 0963 022 030
Quantity Description
4
12
4
8
16
4
2
4
4
In principle, two lateral attachment points have
been planned per vehicle equipment block. With
appropriately trimmed attachment sheeting, you can
attach two further points in high vehicle equipment
blocks. Sheeting can be trimmed to the matching
angles if required for assembly. A further option is
using the sheets as packing plates behind the vehicle
panel if this proves to be too weak.
The rubber washers serve to mute vehicle vibrations
and torsions. They must always be used, especially
in high and long vehicle equipment.
It may be necessary to provide the WÜRTH compo-
nents with new boreholes.
Please ensure that the suspension bars of the guide
rails are not damaged and that the boreholes are
always easily accessible.
(Fig. IV/V)
Side attachment
(2 straight / 2 bent at 90°)
(Self-locking) M 8
Hexagonal nut
Allen screw M 8 x 30
Allen screw M 8 x 20
Washer 8.5 x 25
Rubber washer 8.2 x 30
Attachment plate 55 x 24.5
Screw sockets M 8
Riveting nut M 8
x 7