Safety Instructions For Maintenance; Assembly; To Install The Body Of The Product; To Install The Handlebar (541Rst) - Husqvarna 531RS Manual De Usuario

• Empty the fuel tank before long-term storage. Obey
the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cable before you put the
product into storage to make sure that the engine
does not start accidentally.
WARNING: Read the safety chapter before
you assemble the product.

To install the body of the product

• Attach the engine (A) to the tube (B) with 4 screws
(C).
A
B
C
To install the handlebar(531RS,
541RS)
1. Install the handlebar in the handlebar clamp on the
shaft.
10

Safety instructions for maintenance

• If you cannot adjust the idle speed to make the
cutting attachment stop, speak to your service
center. Do not use the product until the product is
correctly adjusted or repaired.

Assembly

2. Install the protective sleeve.

To install the handlebar (541RST)

1. Remove the screw behind the throttle handle.
2. Install the throttle handle to the right handlebar.
3. Align the hole behind the throttle handle with the
hole in the handlebar.
4. Put the screw through the holes. Tighten the screw.
1274 - 002 -