To Attach And Remove The Guard Extension; To Install Blades And Trimmer Heads; To Attach A Blade Guard, Grass Blade And Grass Cutter - Husqvarna 531RS Manual De Usuario

10. Connect the stop switch wires (H) with the
connectors from the engine.
H
11. Install the dust cover (J).
12. Install the air filter cover.

To install blades and trimmer heads

WARNING: Only use the approved guard for
Accessories on page 24 . A
the blades. See
defective guard can cause injury.
WARNING: If you operate the product with a
grass blade, first install the correct
handlebar, blade guard and harness .
WARNING: If you do not install the the
blades correctly, it can cause injury.
1. Make sure that the lifted section on the drive disc/
support flange engages correctly in the center hole
of the blades.
12
J
2. Install the blades.

To attach and remove the guard extension

The guard extension is used on the cutting attachment
guard. Attach the guard extension when you use a
trimmer head or plastic blades. Remove the extension
guard when you use a grass blade.
• Put the guide on the guard extension into the slot on
the cutting attachment guard. Lock the 4 locking
hooks into position.
• Release the locking hooks with a screwdriver to
remove the guard extension.
To attach a blade guard, grass blade and
grass cutter
CAUTION: Make sure that the guard
extension is removed.
Note: Use the recommended blade guard. Refer to
Accessories on page 24 .
1274 - 002 -