To Attach The Trimmer Guard And The Trimmer Head; To Install The Transport Guard - Husqvarna 531RS Manual De Usuario

1. Install the blade guard to the shaft. Attach the blade
guard with the bolt (L).
L
A
2. Attach the drive disc (B) to the output shaft.
3. Turn the output shaft until 1 of the holes in the drive
disc aligns with the hole in the gear housing.
4. Put the locking pin or hex key (C) into the hole to
lock the shaft.
5. Put the blade (D), support flange (E) and support
cup (F) on the output shaft.
6. Install the nut (G). Use the combination wrench and
tighten the nut to torque 35-50 Nm. Hold the shaft of
the combination wrench as near the blade guard as
possible.
7. To tighten the nut, turn the combination wrench in
the opposite direction to the direction of rotation.
Note: Left hand thread.
To attach the trimmer guard and the trimmer
head
Note: Make sure to use the correct trimmer guard for the
correct trimmer head.
1. Attach the correct trimmer guard/combination guard
(A) for the trimmer head.
2. Hang the trimmer guard/combination guard (A) on
the 2 hooks on the plate holder (M).
1274 - 002 -
3. Install the trimmer guard/combination guard around
G
F
E
D
A
B
C
4. Put the locking pin or hex key (C) in the groove on
5. Attach the drive disc (B) and support flange (E) on
6. Turn the output shaft until one of the holes in the
7. Install the locking pin or hex key (C) in the hole to
8. Assemble the trimmer head/plastic blades (H). Turn
9. To disassemble, follow the instructions in the

To install the transport guard

1. Install the blade in the transport guard (A).
2. Put the two fasteners (B) into the slots (C) to attach
the shaft and tighten it with the bolt (L). Use the
locking pin or hex key (C).
H
L
M
C
A
the screw head and tighten.
the output shaft.
drive disc aligns with the hole in the gear housing.
lock the shaft.
H
H
the trimmer head/plastic blades counterclockwise.
opposite sequence.
the transport guard.
B
A
C
A
E
B
M
L
13