Safety Instructions For Maintenance - Husqvarna 320iL Manual De Usuario

• Use the battery in temperatures between -10
°C (14 °F) and 40 °C (104 °F).
• Do not clean the battery or the battery charger
with water. Refer to
battery and the battery charger on page 19 .
• Do not use a defective or damaged battery.
• Keep batteries in storage away from metal
objects such as nails, screws or jewelry.
• Keep the battery away from children.
Battery charger safety
WARNING:
instructions that follow before you use
the product.
• Risk of electrical shock or short circuit if the
safety instructions are not obeyed.
• Use an approved grounded mains socket that
is not damaged.
• Only use Husqvarna branded chargers.
• Do not try to disassemble the battery charger.
• Do not use a defective or damaged battery
charger.
• Do not lift the battery charger by the power
cord. To disconnect the battery charger from a
mains socket, pull out the plug. Do not pull the
power cord.
• Keep all cables and extension leads away
from water, oil and sharp edges. Make sure
that the cable is not caught between objects,
for example, doors, fences or equivalent.
• Do not use the battery charger near
flammable materials or materials that can
cause corrosion. Make sure that the battery
charger is not covered. Pull out the plug to the
battery charger if there is smoke or fire.
• Only charge the battery indoors in a location
with good airflow and away from sunlight.
Do not charge the battery outdoors. Do not
charge the battery in wet conditions.
• Only use the battery charger where the
temperature is between 5 °C (41 °F) and
40 °C (104 °F). Use the charger in an
environment which has a good airflow, dry
and free from dust.
• Do not put objects into the cooling slots of the
battery charger.
12
To clean the product, the
Read the warning
• Do not connect the battery charger terminals
to metal objects as this can short circuit the
battery charger.
• Use approved mains sockets that are not
damaged. Make sure that the cord of the
battery charger is not damaged. If extension
cables are used, make sure that the extension
cables are not damaged.
• Use a residual-current device (RCD) for
increased security. A residual-current device
is fitted to protect operators in case an
electrical fault should occur.

Safety instructions for maintenance

WARNING:
instructions that follow before you do
maintenance on the product.
• Remove the battery before you do
maintenance, other checks or assemble the
product.
• The operator must only do the maintenance
and servicing shown in this operator's manual.
Turn to your servicing dealer for maintenance
and servicing of a larger extension.
• Do not clean the battery or the battery
charger with water. Strong detergent can
cause damage to the plastic.
• If you do not do maintenance, it decreases the
life cycle of the product and increases the risk
of accidents.
• Special training is necessary for all servicing
and repair work, especially for the safety
devices on the product. If not all checks
in this operator's manual are approved after
you have done maintenance, turn to your
servicing dealer. We guarantee that there are
professional repairs and servicing available
for your product.
• Only use original spare parts.
• Maintenance, replacement, or repair of the
emission control devices and system may
be performed by any nonroad engine repair
establishment or individual.
Read the warning
1511 - 009 - 07.07.2022