Fitting The Trimmer Guard And Trimmer Head; Fitting The Transport Guard; Adjusting The Harness And Brush Cutter; Adjusting The Backplate Height - Husqvarna 553RBX Manual De Instrucciones

the spanner in the opposite direction to the direction
of rotation (Caution! left-hand thread).
Fitting the trimmer guard and trimmer
head
• Fit the correct trimmer guard (A) for use with the
trimmer head. CAUTION! Ensure that the guard
extension is fitted.
L
M
A
• Hook the trimmer guard/combination guard onto the
fitting on the shaft and secure with the bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the blade shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
H
H
• To dismantle, follow the instructions in the reverse
order.
ASSEMBLY
G
E
F
D
B
C
H
B
C
M L

Fitting the transport guard

• Insert the blade in the transport guard (A).
• Snap the two fasteners (B) into the slots (C) to secure
the transport guard.
Adjusting the harness and brush
cutter

Adjusting the backplate height

• Loosen the two fasteners holding the backplate.
A
• Loosen the backplate from the frame on one side.
–
English 13