Installing Keg Tap - Klarstein Big Spender Manual De Instrucciones

INSTALLING KEG TAP

1 Make sure the black pull handle of the tap is in the closed (up) position before
installing it on the keg (Fig. 1 - below). Insert the keg coupler into the locking neck
of the beer keg and turn clockwise ¼ to lock it into position (Fig. 2 - below). This
means that it is secured to the keg.
2 When connecting the beer line, it is very important that the black rubber washer
be installed inside the wing nut before connecting the beer line to the tap ( See
Illustration A below). Remove the black rubber protective cap located on top of tap
and screw the Wing nut with the rubber washer. Tighten it firmly by hand.
(Fig.2 - below).
3 Attach the CO2 line end of the tube to the hose connection on the tap. Next, secure
the tube by using the remaining self-locking plastic snap-on clamp to ensure that
there are no leaks. Secure the clamp tightly with pliers (Fig. 3 - below).
4 Make sure the beer tower faucet is in the closed (handle pointing straight back)
position before connecting the tap to the keg. To secure the tank connection, pull the
tapping handle out and push down until it locb into position. Listen for the „click" of
the pull handle when it shifts into the final downward position (Fig. 4 - below).This
will open the beer and CO2 gas valves. The keg is now tapped.
5 Carefully tilt the keg and rest the edge on the keg floor support on the bottom of the
interior cabinet. Slide the beer keg slowly, ensuring that it is properly located (Fig.
5 - below) and carefully close the door.
Fig. 1
Fig. 4
Fig. 2
Fig. 5
Fig. 3
EN
27