Maintenance; Maintenance And Checks Of The Safety Devices On The Product; To Do A Check Of The Front Hand Guard; To Do A Check Of The Brake Trigger - Husqvarna 120i Manual De Usuario

Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance and checks of the
safety devices on the product

To do a check of the front hand guard

Regularly do a check of the front hand guard and the
inertia brake release.
1. Make sure that the front hand guard is not damaged
and that there are no defects, such as cracks.
2. Make sure that the front hand guard moves freely
and that it is attached safely to the product.
3. Put the product, with the motor off, on a stump or
other stable surface.
22

Maintenance

4. Hold the rear handle and let go of the front handle.
Let the product fall against the stump.
5. Make sure that the chain brake engages as the
guide bar hits the stump.

To do a check of the brake trigger

1. Put the product on stable ground and start it. See
start the product on page 14 .
2. Wrap your fingers and thumbs around the handles
and hold the product tight.
3. Apply full power and tilt your left wrist against the
front hand guard to engage the chain brake. The
saw chain must stop immediately.
WARNING: Make sure that the saw
chain does not touch the ground or other
objects.
WARNING: Do not let go of the front handle!
To
805 - 002 -