To Cut A Trunk With Support On One End; To Cut A Trunk On The Ground; To Cut A Trunk With Support On Two Ends - Husqvarna 120i Manual De Usuario

WARNING: Do not try to cut trunks in a
pile. That increases the risk of kickback
and can result in serious injury or death.
2. Cut the trunks one by one.
3. Remove the cut pieces from the cutting area.
WARNING: The kickback risk increases
if you keep cutting pieces in the cutting
area. It is also a risk that you do not
keep your balance during operation.

To cut a trunk on the ground

WARNING: Follow the steps below to
prevent the saw chain from touching the
ground or an object.
Note: To cut trunks on the ground decreases the risk
that the saw chain gets trapped or that the object breaks.
1. Cut through the trunk on the pull stroke. Do not let
the saw chain touch the ground when you complete
the kerf. Keep full power but be prepared for sudden
accidents.
2. To prevent accidents, cut approximately 2/3 through
the trunk and then stop. Turn the trunk and cut from
the opposite side to complete the task.
805 - 002 -

To cut a trunk with support on one end

WARNING: Follow the steps below to
prevent the trunk from breaking before the
cutting is complete.
1. Cut on the push stroke approximately 1/3 through
the trunk.
2. Cut through the trunk on the pull stroke until the two
kerfs touch.

To cut a trunk with support on two ends

WARNING: Follow the steps below to
prevent the saw chain from getting trapped
in the trunk.
1. Cut on the pull stroke approximately 1/3 through the
trunk.
2. Cut through the remaining part of the trunk on the
push stroke until the two kerfs touch.
WARNING: If the saw chain gets trapped in
the trunk, stop the motor! Do not try to pull
the product free. If you do, there is a risk of
injury when the product suddenly breaks
free. Use a lever to open up the cut and free
the product.
17