Double Insulation; Polarized Plugs - DeWalt DW735 Manual De Instrucciones

Defi nitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to these
symbols.
DANGER: Indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which,
if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which,
if not avoided, may result in minor or moderate injury.
NOTICE: Indicates a practice not related to personal injury
which, if not avoided, may result in property damage.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR
ANY D WALT TOOL, CALL US TOLL FREE AT: 1-800-4-D
E
(1-800-433-9258).
WARNING: To reduce the risk of injury, read the instruction
manual.
SAVE THESE INSTRUCTIONS
Important Safety Instructions for All Tools
WARNING: For your own safety, read the instruction manual before
operating the planer. Failure to heed these warnings may result in
personal injury and serious damage to the planer. When servicing this
tool, use only identical replacement parts. Have damaged cords
replaced by an authorized service center.

DOUBLE INSULATION

Double insulated tools are constructed throughout with two separate
layers of electrical insulation or one double thickness of insulation
between you and the tool's electrical system. Tools built with this
insulation system are not intended to be grounded. As a result,
your tool is equipped with a two prong plug which permits you
to use extension cords without concern for maintaining a ground
connection.
NOTE: Double insulation does not take the place of normal safety
precautions when operating this tool. The insulation system is for
added protection against injury resulting from a possible electrical
insulation failure within the tool.

POLARIZED PLUGS

To reduce the risk of electric shock, this equipment has a polarized
plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully into the outlet, reverse
WALT
E
the plug. If it still does not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
WARNING: When using electric tools, basic safety precautions
should always be followed to reduce the risk of fire, electric shock,
and personal injury, including the following:
General Safety Instructions
• KEEP GUARDS IN PLACE and in working order.
• REMOVE ADJUSTING KEYS AND WRENCHES. Form habit
of checking to see that keys and adjusting wrenches are removed
from tool before turning it on.
• KEEP WORK AREA CLEAN. Cluttered areas and benches invite
injuries.
• DON'T USE IN DANGEROUS ENVIRONMENT. Don't use
power tools in damp or wet locations, or expose them to rain.
1