Grinder Operation - Metabo HPT G 14DSL Instrucciones De Seguridad Y Manual De Instrucciones

8. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the remaining battery indicator lamp lights and the
battery remaining power can be checked. (Fig.6)
When releasing your fi nger from the remaining battery
indicator switch, the remaining battery indicator lamp
goes off . The table 5 shows the state of remaining
battery indicator lamp and the battery remaining
power.
State of lamp
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Remaining battery
indicator switch
NOTE
○ Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
○ To save the battery power consumption, the
remaining battery indicator lamp lights while pressing
the remaining battery indicator switch.
Table 5
Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
Remaining battery
indicator lamp
Fig. 6

GRINDER OPERATION

CAUTION
To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
NOTE
○ To prevent injuries, this product has a function that
prevents unexpected motor rotation when the battery
is inserted. The motor will not run if the battery is
inserter while the switch is still ON. After installing the
battery, turn the switch off and then back on again.
○ The G14DSL and G18DSL models are equipped with
a protection function that will shut down the tool in the
event of an overload.
Should the tool shut down due to an overload, turn the
power off and then turn it back on again.
An overload that stops tool operation and lasts more
than 10 seconds may not be released by turning the
power off and on. Should this happen, remove the
battery from the tool and reinstall it before turning on
the power switch.
1. Hold the grinder fi rmly by its housing and side handle
(Fig. 1).
The grinder produces a counterforce which must be
controlled by fi rmly holding onto the grinder.
2. Turn the grinder "on". (Fig. 7)
While holding the grinder fi rmly, use one fi nger to slide
the switch to the "on" position.
ON
3. Use light grinding pressure.
There is no need to press hard when grinding. Usually
the grinder's own weight is suffi cient to allow the
required light contact with the surface to be ground.
English
Switch
OFF
Fig. 7
15