Grinder Operation - Metabo HPT G 3612DVE Instrucciones De Seguridad Y Manual De Instrucciones

Always-ON
mode
Panel
display
Always ON
State (turn off after
60 minutes)
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 60 minutes.
12. LED light warning signals
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
are triggered during operation, the LED light will blink
as described in Table 8. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Safeguard
LED Light Display
Function
Overload
protection On 0.1 second/
off 0.1 second
Kickback
protection
On 0.5 second/
Overheat off 0.5 second
protection
Table 7
SW
Always-OFF
interlocked
mode
mode
Light only
SW-ON
(Automatically
goes out
approximately Always OFF
10 seconds
after the
switch is
released)
Table 8
Corrective
Action
Remove the
cause of the
overburdening.
Allow the tool
and battery
to thoroughly
cool.

GRINDER OPERATION

CAUTION
To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
NOTE
○ To prevent injuries, this product has a function that
prevents unexpected motor rotation when the battery
is inserted. The motor will not run if the battery is
inserter while the switch is still ON. After installing the
battery, turn the switch off and then back on again.
○ This product is equipped with a protection function
that will shut down the tool in the event of an overload.
Should the tool shut down due to an overload, turn the
power off and then turn it back on again.
An overload that stops tool operation and lasts more
than 10 seconds may not be released by turning the
power off and on. Should this happen, remove the
battery from the tool and reinstall it before turning on
the power switch.
1. Hold the grinder fi rmly by its housing and side handle
(Fig. 2).
The grinder produces a counterforce which must be
controlled by fi rmly holding onto the grinder.
2. Turn the grinder "on".
<G3612DVE> (Fig. 15)
While holding the grinder fi rmly, slide the switch to
the "ON" position with one fi nger to turn on the tool.
Releasing the switch will turn off the tool.
For continued operation, slide the switch to the "ON"
position and press down the "ON" position of the
switch to lock it in place.
Turn the grinder "OFF" (Fig. 15)
Press the "OFF" position of the switch to release the
lock and turn the grinder off .
Switch
ON
LOCK
English
OFF
Fig. 15
19