How The Machine Works; Brush And Pad Information; Machine Setup - Tennant T2 Manual De Operador

HOW THE MACHINE WORKS

Water and detergent from the solution tank flow to the
floor through a manually controlled solution valve. The
brush uses the detergent and water solution to scrub
the floor clean. As the machine moves forward, the
squeegee wipes the dirty solution from the floor into the
recovery tank.

BRUSH AND PAD INFORMATION

For best cleaning results use the appropriate brush
type for your cleaning application. Refer to the Parts
manual for part number information.
Polypropylene Bristle Scrub Brush (Black) --
Part No. 1016765
This general purpose polypropylene bristle scrub brush
is used for scrubbing lightly compacted soilage. This
brush works well for maintaining concrete, wood and
grouted tile floors.
Soft Nylon Bristle Scrub Brush (White) - -
Part No. 1016764
Recommended for cleaning coated floors without
removing finish. Cleans without scuffing.
Super Abrasive Bristle Scrub Brush (Gray) - -
Part No. 1016763
Nylon fiber impregnated with abrasive grit to remove
stains and soilage. Strong action on any surface.
Performs well on buildup, grease, or tire marks.
Polishing Pad (White) - -
Used to maintain highly polished or burnished floors.
Buffing Pad (Red) - -
Used for light duty scrubbing without removing floor
finish.
Scrubbing Pad (Blue) - -
Used for medium to heavy--duty scrubbing. Removes
dirt, spills, and scuffs and leaves surface clean ready
for recoating.
Stripping Pad (Brown) - -
Used for stripping of floor finish to prepare the floor for
recoating.
Heavy Duty Stripping Pad (Black) - - Used for
aggressive stripping of heavy finishes/sealers, or very
heavy duty scrubbing.
Tennant T2 (08- -11)

MACHINE SETUP

ATTACHING SQUEEGEE ASSEMBLY
1. Park machine on a level surface and remove key.
2. Raise the squeegee mount bracket by moving the
squeegee lift lever to the right (Figure 2).
3. Mount the squeegee assembly to the squeegee
pivot bracket as shown (Figure 3). Make sure the
knobs are completely seated into the slots before
securing knobs.
4. Connect the vacuum hose to the squeegee
assembly. Loop the hose as shown using the hose
clip provided (Figure 4).
ENGLISH
FIG. 2
FIG. 3
FIG. 4
7