Machine Installation; Uncrating Machine; Installing Batteries - Tennant T2 Manual De Operador

ENGLISH

MACHINE INSTALLATION

UNCRATING MACHINE

1. Carefully check the shipping crate for signs of
damage. Report damages at once to carrier.
2. Check the contents list. Contact distributor for
missing items.
Contents:
12V Batteries (Optional)
S
2--Foam Battery Spacers
S
Battery Tray
S
Battery Cable
S
Battery Terminal Boots (4)
S
Squeegee Assembly
S
Pad Driver/Brush (Optional)
S
3. Roll machine off pallet using the attached ramp.
ATTENTION: Do not roll machine off pallet unless
ramp is used, machine damage may occur.

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Hood Open When
Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Battery Specifications:
Two 12 volt, 105Ah/20h lead acid (578426) deep cycle
batteries.
1. Park the machine on a level surface and remove
the key.
2. Carefully install the batteries into the battery
compartment as shown (Figure 1).
3. Connect the battery cables as shown (Figure 1).
6
BLK
RED
Foam Spacers
IMPORTANT: If your machine is equipped with the
on- -board battery charger, make sure that the
charger is properly set for your battery type before
charging (See USING THE ON- -BOARD BATTERY
CHARGER).
105Ah
Machine Front
FIG. 1
Tennant T2 (08- -11)