Mechanical Hazards; First Aid; Protective Device - Hilti GX120-ME Manual De Instrucciones

e) Keep the workplace tidy. Objects which could
cause injury should be removed from the work-
ing area. Untidiness at the workplace can lead to
accidents.
f) Keep the grips dry, clean and free from oil and
grease.
g) Wear non-skid shoes.
h) Take the influences of the surrounding area into
en
account. Do not expose the tool to rain or snow
and do not use it in damp or wet conditions. Do
not use the tool where there is a risk of fire or
explosion.

5.1.4 Mechanical hazards

a) Select the correct fastener guide and fastener
combination for the job on hand. Failure to use
the correct combination of these items may result in
damage to the tool and/or unsatisfactory fastening
quality.
b) Use only fasteners of a type approved for use with
the tool.
c) Never fill the magazine with fasteners unless it is
correctly fitted to the tool. The fasteners could be
ejected uncontrollably.
5.1.5 Thermal hazards
a) If the tool has overheated, allow it to cool down.
Do not exceed the recommended fastener driving
rate.
b) Always wear gloves if the tool has to be dis-
mantled for cleaning or maintenance before it
has been allowed to cool down.
5.1.6 Gasses
Liquid gas under pressure:
Observe the hazard warnings and first-aid instruc-
tions printed on the gas can and in the instructions
for use.
18
The gas is extremely flammable (contains: isobutane,
propene).
Refilling the gas can is not permissible.
a) Do not use damaged gas cans.
b) Do not attempt to force the gas can open. Do not
incinerate or crush the can and do not attempt to
reuse it for any other purpose.
c) Never spray the gas toward persons or other living
beings.
d) Keep the gas away from all sources of ignition
such as naked flames, sparks, pilot lights, static
discharge and very warm surfaces.
e) Do not smoke while using the tool.
5.1.6.1 Storage
a) Do not store gas cans in inhabited rooms or in
rooms connected to inhabited rooms.
b) Store the gas cans in a dry, well-ventilated place.
c) Store the gas cans out of reach of children.
d) Do not expose gas cans to direct sunlight or
temperatures above 50°C (122°F).
e) Recommended storage temperature: 5°C to 25°C
(41°F to 77°F).

5.1.6.2 First aid

Read the material safety data sheet for information
about use, care and maintenance and first-aid meas-
ures.
a) Direct skin contact with the liquid gas may cause
frostbite or a serious freezing injury similar to a
burn.
b) In case of inhalation of the gas: The person af-
fected should be taken into the open air and
brought into a comfortable position.
c) In case of unconsciousness: Bring the person af-
fected into a secure recovery position. Should the
person stop breathing, apply artificial respiration
and supply oxygen if necessary.
d) In case of gas contact with the eyes: Rinse the
open eyes under running water for one minute.
e) In case of gas contact with the skin: Wash the
contact surface carefully with warm water and
soap. Subsequently apply a skin cream.
Consult a doctor if necessary.
f)

5.1.7 Protective device

Never use the tool if the applicable safety devices
have been damaged or removed.