Safety Instructions - Urrea 2473 Manual De Usuario

E N G L I S H

SAFETY INSTRUCTIONS

• Steel and other materials
can shatter,
use personal
equipment;
work gloves,
eye wear, security boots
and that complies with the
appropriate safety code
when operating the press.
• If you detect anything that
may indicate
structural
stop using
immediately and inspect it
thoroughly.
• Bolt the press to the floor
if it is to be used on bulky
or unstable items. Ensure
that every work piece is center-loaded and
secure.
• Always position the press against a wall. If
the press is situated in the open workshop,
it is essential that a guard be placed at the
rear of the unit. This will prevent injury to
bystanders in the event of the work piece
ejecting suddenly.
• DO NOT use press to compress springs or
any other item that could disengage and
cause a potential hazard.
• Use a qualified person to maintain the
press in good condition. Keep it clean for
best and safest performance.
•
rated capacity.
t
•
force to a work piece and
always use the pressure
gauge
determine the applied load.
•
purpose for which it is
intended. DO NOT use it for
any other purpose it is not
designed to perform.
• Do not introduce any part of the body in
the work area.
• Never wear baggy clothes, ties, watches,
rings, chains, etc., when using the press.
• Long hair should be tied up.
4
so always
protective
heavy-duty
protective
imminent
failure,
the press
DO NOT exceed the
Never apply excessive
to accurately
Use this press for the
• DO NOT operate the press when you are
tired or under the influence of alcohol,
drugs or any intoxicating medication.
• DO NOT allow untrained people operate
the press.
• Keep children and unauthorized people
away from the work area.
• Keep proper balance and footing, do not
over-reach and wear nonskid footwear.
• Only use this press on a surface that is
stable, level, dry and not slippery and
capable of sustaining the load.
• Keep the surface clear, tidy and free from
unrelated materials and ensure that there
is adequate lighting.
• Inspect the press before each use.
• DO NOT use if bent, broken, cracked,
leaking or otherwise damage.
• Check to ensure that all applicable bolts
and nuts are firmly tightened.
• DO NOT make
modifications to the press.
• DO NOT use brake fluid or
any other improper fluid
and avoid mixing different
types of oil when adding
hydraulic oil. Use oil HL or
HM.
• DO NOT expose the press
to the rain or any other
kind of bad weather.
• Repair by qualified
persons.
PLEASE KEEP THIS INSTRUCTION MANUAL
SAFE FOR FUTURE USE.
WARNING:
The warnings, cautions and instructions
discussed in this manual cannot cover all
conditions and situations that may occur.
It must be understood by the operator
that common sense and caution are factors
which cannot be built into this product, but
must be supplied by the operator.
ASSEMBLY
Use the exploded drawing as your guide
to assemble. Lay all parts and assemblies
out in from of you before beginning. The
any