Features; Operation Instructions - Urrea PC800A Manual De Usuario Y Garantía

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1
2
3
1. HEAD OUTLET.
2. GUARD SLEEVE.
3. HEAT GUN BODY.
4. AIR INLET.
5. ON / OFF SWITCH WITH AIR BLOW SETTING.
6. HEAT RANGE REGULATOR

OPERATION INSTRUCTIONS

HEAT SETTINGS
This heat gun has two heat settings and one
ventilation setting:
Low heat (2 + lowest set-
ting on the heat wheel):
For use where the work-
piece or surroundings must
not be allowed to get too
hot.
High heat (2 + highest setting of heat wheel):
For faster heat up time of the workpiece
where you can also operate the gun at a great-
er distance.
Ventilation mode (1): In this position, the air
outlet, discharges nothing more than air, this
allows the heat gun to cool before storing.
OPERATION
Before starting the job it is advisable to test
the workpiece for the ideal temperature to
use. The table below gives an indication of the
likely heat settings required but always start
with the low heat setting.
All applications, with the exception of remov-
ing paint from the window frames, can be per-
10
4
6
5
formed without using a nozzle, however for
best results nozzles are recommended.
SUGGESTED RATINGS
Paint Stripping; High Setting
Defrosting Pipes; High Setting
Bending Plastic; Low Setting
Heat Shrinking Plastic; Low Setting
NOZZLES
The kit is supplied with 4 different shaped noz-
zles, which can be used as follows:
CONCENTRATOR NOZZLE
This nozzle directs a concen-
trated heat flow to the work-
piece. It is ideal for use when
removing paint in awkward
corners, crevices, mouldings,
beading, architraves or
whenever precise paint re-
moval is required.
One of the nozzles has a nar-
rower end so it can direct the
hot air directly to the piece
of work.
DEFLECTOR NOZZLE
This nozzle directs a long
narrow heat pattern to the
workpiece, and is ideal for
removing paint or varnish
from large flat surfaces such
as skirting boards, doors,
stairs etc. It should be used in conjunction with
a flat scraper. Vinyl tiles can be removed by
softening the tile and adhesive.
GLASS PROTECTION NOZZLE
This nozzle deflects the heat
away from glass or other
fragile areas and back onto
the workpiece.
REFLECTOR NOZZLE
This nozzle disperses the
heat flow evenly around the
whole workpiece. It is ideal
for defrosting frozen pipes,
soldering pipe work, bend-
ing plastics and heat-shrink-
ing electrical parts.