Starting And Stopping; Starting; Cold Engine; Warm Engine - Husqvarna T540 XP II Manual De Instrucciones

Starting and stopping

WARNING! Note the following before
!

starting:

The chain brake must be engaged when
the chainsaw is started to reduce the
chance of contact with the moving chain
during starting.
Never start a chainsaw unless the bar,
chain and all covers are fitted correctly.
Otherwise the clutch can come loose and
cause personal injuries.
Place the machine on firm ground. Make
sure you have a secure footing and that
the chain cannot touch anything.
If you need to start the chainsaw in the
tree, see instructions under the heading
Starting the saw in the tree, under the
section Working techniques.
Keep people and animals well away from
the working area.
Long term inhalation of the engine's
exhaust fumes, chain oil mist and dust
from sawdust can represent a health risk.
Starting
The chain brake should be activated when starting the
chainsaw. Activate the chain brake by pushing the front
hand guard forwards.

Cold engine

Air purge: Press the primer bulb repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
STARTING AND STOPPING
Choke: Set the choke control in the choke position.
Grip the front handle with your left hand and push the
chainsaw to the ground. Grip the starter handle with your
right hand and pull out the starter cord slowly until you feel
a resistance (as the starter pawls engage) and then pull
firmly and rapidly. Never wrap the starter cord around
your hand
CAUTION! Do not pull the starter cord all the way out and
do not let go of the starter handle when the cord is fully
extended. This can damage the machine.
Pull the choke control back as soon as the engine fires
which can be heard through a "puff" sound. Keep on
pulling the cord powerfully until the engine starts.

Warm engine

Air purge: Press the primer bulb repeatedly until fuel
begins to fill the bulb. The bulb need not be completely
filled.
Start throttle position: Activate start throttle setting by
moving the choke control to the choke position and then
pulling it back again.
Grip the front handle with your left hand and push the
chainsaw to the ground. Grip the starter handle with your
right hand and pull out the starter cord slowly until you feel
a resistance (as the starter pawls engage) and then pull
–
English 23