Cleaning the humidification discs and tub
You can wipe the humidification discs and tub with a damp cloth or clean them thoroughly and easily in the
dishwasher.
Lift off the upper cover, remove the humidification discs
from the tub and place them in the dishwasher. Unlock
the water level sensor (Figure 1) and remove it (Figure 2). If
there is insufficient space in the dishwasher, create extra
space by removing the cutlery basket, for example. The
humidification discs and tub must not be bent or jammed
when being placed in the dishwasher.
Set the dishwasher to a gentle cycle (for cleaning glass) and
if possible remove the part before the drying process. The
cycle must not exceed a temperature of 50 °C – otherwise the plastic parts may deform.
Only continue to use the device when the exterior of the tub is completely dry.
Clean the water level sensor
You can clean the lower half of the water level sensor in a cleaning bath. Ensure that the upper half of the
water level sensor is not exposed to any harsh cleaning products. The water level sensor must not be cleaned
in the dishwasher.
Descaling the humidification discs and the tub
Use a basic descaling cleaning solution.
Note: A light build-up of limescale on the humidification discs increases the evaporation effect.
Storage
If you do not plan to use the device for a relatively long period of time, we recommend that you thoroughly
empty, clean and dry the device and store it in the original packing in a dry environment, ensuring it is not
weighed down by additional items.
Disposal
Observe the local regulations for material disposal. Dispose of the unit in accordance with EC Direc-
tive 2002/96/EC – WEEE (Waste Electrical and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.
10. LW 110 technical data
Dimensions (L x W x H)
Cable length
Weight when empty
Power supply unit.
Output
Suitable for rooms
Maximum capacity
Subject to technical modifications.
11. Warranty
Limited Lifetime Warranty For Original Purchaser
Your Beurer Air Washer, Model LW 110, excluding the battery, is warranted to be free from defects in materi-
als and workmanship for the life of the product under normal conditions of intended use and service. This
warranty extends only to the original retail purchaser and does not extend to retailers or subsequent owners.
We will, at our option, repair or replace the Beurer Air Washer, Model LW 110, without additional charge, for
any part or parts covered by these written warranties. No refunds will be given. Repair or replacement is our
only responsibility and your only remedy under this written warranty. If replacement parts for defective materi-
als are not available, Beurer reserves the right to make product substitutions in lieu of repair or replacement.
30 x 30 x 34 cm
approx. 2 m
approx. 6 kg
110 – 120 Volt / 60 Hz
53 Watt
up to approx. 36 m²
approx. 7.25 litres
10
Figure 1
Figure 2