Additional Information; Troubleshooting; Power; Basic Operation - Yamaha BD-S1067 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 224

ADDITIONAL INFORMATION

Refer to the table below when this Player does not function properly. If the problem you are experiencing is not listed
below or if the instruction below does not help, turn off this Player, disconnect the power cable, and contact the nearest
authorized Yamaha dealer or service center.

■ Power

Problem
No power.
The Player power is turned off.

■ Basic operation

Problem
The remote control does not work.
Buttons do not work.
Password is forgotten.

■ Disc playback

Problem
The Player cannot play a disc.
Video stops.
The Player makes a snapping sound
when starting playback or loading a
disc.

TROUBLESHOOTING

Possible causes and solutions
– Connect the AC power cable properly.
– Press (p) on the front panel to turn on the power.
– The power will be automatically turned off after 10 continuous minutes of inactivity (no
playback).
Possible causes and solutions
– Use the remote control within its operating range. (p. 5)
– Replace the batteries. (p. 5)
– Check the ID settings for the main unit and the remote control. (p. 9)
– Press and hold p on the front panel for around 5 seconds to restart this Player.
– To completely reset this Player, unplug the power cable from the AC outlet for 5 - 10
seconds, plug the power cable to the AC outlet again, and then turn on this Player.
– Press and hold
and
and playback is stooped to set the Player to default setting (Security setting (p. 30) is
also reset).
Possible causes and solutions
– Take out the disc and clean it. (p. 4)
– Make sure that the disc is loaded properly (aligned in disc tray and label-side up). (p. 4)
– Use a disc supported by the Player. (p. 3)
– Remove the disc and then check whether the Player supports the disc or not. (p. 3)
– Check the region code. (p. 3)
– Check whether the disc is defective by trying another disc.
– The CD-R/RW, DVD+R/RW/R DL, and DVD-R/RW/R DL must be finalized. (p. 3)
– The Player will stop if it senses shock or vibration.
– These sounds are not malfunctions of the Player but are normal operating conditions.
on the front panel simultaneously when no disc is inserted
5
37
En

Publicidad

Tabla de contenido
loading

Tabla de contenido