Adjust The Brakes; Pneumatic Tyre Changing - Vermeiren Jazz S50 Manual De Instrucciones

3.4

Adjust the brakes

L WARNING:
Risk of injury – Brakes may only be adjusted by your specialist
dealer.
Adjust the brakes according following rules:
1. Install the wheels according § 2.2.
2. Disconnect the brakes by pulling lever

3. Loosen bolt so the brake mechanism can slide over the frame
4. Pull the brake mechanism over the frame
adjustment of the brakes shall be in the range of the marked dashes  on the brake
mechanism.
5. Retighten the bolt 
6. Check working of the brakes.
7. If necessary repeat the above steps until the brakes are adjusted well.
A
3.5

Pneumatic tyre changing

L CAUTION:
Chance of damage - If handled improperly, the rim might be damaged.
Rather let an expert perform these activities.
NOTE:
Always make sure that the wheels are sufficiently inflated, since it could
affect the driving behaviour.
NOTE:
We do not accept any liability for wheels not supplied by the
manufacturer.
NOTE:
There must be no air in the tube before it can be removed.
If you want to change the tyres or inner tubes, you should note the following:
1. Let all the air out of the inner tube.
2. Insert a tyre lever between the tyre and the rim.
3. Slowly and gently push the tyre lever downwards. This will pull the tyre over the edge
of the rim.
4. Then move the lever along the rim, the tyre will jump out.
5. Now carefully remove the tyre from the rim and then remove the tube.
L
WARNING:
Chance of damage and injury - When mounting a tyre, make sure no
objects or body parts are pinched between the tyre and the rim.
L CAUTION:
Chance of damage - When inflating the tyres, always check that the
pressure is correct. The correct pressure is given on the tyre walls.
L CAUTION:
Chance of damage - Use only inflating equipment which complies
with regulations and indicates the pressure in bar, or use the supplied air pump.

backwards

(Fig B).
Page 14
(Fig A).

to the desired position
(Fig B).
Jazz S50
2018-07
(Fig B).
The
B