Getting familiar with the appliance
In this section we describe the control panel, elements
and displays.
Control panel
Knob positions
Cooking element turned off.
Off
Heat levels can be set continuously:
Circle
Segments
Lowest setting = thin end of
▯
circle segment
Highest setting = thick end of
▯
circle segment
Heating elements
Element
Single element
$
The size of these elements can be matched to your pan size:
Dual element
ð
Triple element
ò
Bridge element
à
Turning on and off
Single elements have only one size cooking surface.
Always use cookware of a suitable size.
Use only inner heating ring: Turn knob along the left segment marked with
▯
Add outer heating ring: Turn knob along the right segment marked with
▯
Use only inner heating ring: Turn knob along the left segment marked with
▯
Add middle heating ring: Turn knob to the middle segment marked with
▯
Add outer heating ring: Turn knob along the right segment marked with
▯
The bridge element combines the front and rear heating elements at the left side into one
long griddle zone. This configuration is ideal for griddles and large pans.
Use as individual elements: Turn the knob of the front left element along the left seg-
▯
ment marked with
.
$
Use as Bridge zone: Use the front element and the middle bridge element to create an
▯
oblong element. Turn the knob of the front left element along the bridge segment
marked with
. Turn the knob of the rear left element to OFF.
ö
Use as Bridge element: Turn the knob of the front left element along the bridge seg-
▯
ment marked with
ö
. Turn the knob of the rear left element along the right segment
marked with
.
ð
Turn both knobs to approximately the same position of the respective segments to
▯
achieve even heating.
Set the knobs to different heat levels to create different heat zones in your pan, e.g.
▯
for searing and stewing.
These instructions apply to more than one cooktop, your
appliance might vary slightly.
Page 2 contains a list of models and dimensions.
Light Indicators
Cooktop is turned on
$
On
Cooking element is turned on
¶
Surface is hot
NOTICE: Always keep the control knobs clean and dry.
Moisture and dirt can affect proper functioning.
.
$
.
ð
$
.
.
ð
.
ò
9