Cleaning The Blender; Storage; Troubleshooting - Bosch MUM5 Serie Instrucciones De Uso

Cleaning the bowl and tools
The bowl and tools are dishwasher­proof.
Do not wedge plastic parts in the dish­
washer, as they could be permanently
deformed during the washing process!
Cleaning the continuous-feed
shredder
All parts of the continuous­feed shredder
are dishwasher­proof.
Tip: To remove the red film after processing
e.g. carrots, pour a little cooking oil on
a cloth and rub the film off the continu­
ous­feed shredder (not the cutting discs).
Then rinse the continuous­feed shredder.

Cleaning the blender

W Risk of injury from sharp blades!
Do not touch blender blades with bare
hands.
The blender jug, lid and funnel are
dishwasher­proof.
Tip: After processing liquids, it is often suffi­
cient to clean the blender without removing
it from the appliance. Pour a little water and
washing­up liquid into the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse out
the blender with clear water.
Important information
If required, clean accessories bag. Follow
care instructions in the bag.

Storage

W Risk of injury!
When the appliance is not in use, pull out
the mains plug.
Fig. K:
■ Store tools and cutting discs in the acces­
sories bag.
■ Keep accessories bag in the bowl.
■ To store in the original packaging, see
Fig. L.

Troubleshooting

W Risk of injury!
Before eliminating a fault, pull out the mains
plug.
Important information for
MUM54../MUM55../MUM56../MUM58..
The Operating indicator flashes if the appli­
ance has been operated incorrectly or the
electronic fuse has tripped or the appliance
is defective.
The swivel arm must be engaged in
every operating position.
Initially try to eliminate the problem which
has occurred with the help of the following
information.
Fault
Appliance does not start.
Remedial action
■ Check the power supply.
■ Check the mains plug.
■ Check swivel arm. Correct position?
Engaged?
■ Screw on blender or bowl as far as
possible.
■ Attach the blender cover and screw on as
far as possible.
■ Attach drive cover to unused drives.
■ The safety lock is active. Switch
appliance to P and then back to the
required setting.
Fault
Appliance switches off during use. The
overload protection feature has been
activated. Too much food was processed at
one time.
Remedial action
■ Switch off the appliance.
■ Reduce processing quantity.
■ Do not exceed permitted maximum quan­
tities (see "Application examples").
Fault
While the drive was running, the release
button was inadvertently pressed. The
swivel arm moves up. The drive switches
off, but does not stop in the tool change
position.
Storage en
25