en
Cleaning
Switching the appliance ON/OFF
W Risk of injury from sharp blade!
Blade is very sharp. Keep hands clear of
the blade. After switching off, the drive
continues for a short time. After work, set
cutting width to 0.
Instantaneous switching
■ 1. Press the switch-on safety device and
hold down.
2. Then press ON button until the power
tool starts running.
3. Release the switch-on safety device
again.
■ To stop the appliance, release the ON
button.
Continuous operation
■ 1. Press the switch-on safety device and
hold down.
2. Then press ON button until the power
tool starts running.
3. Release the switch-on safety device
and the ON button again.
■ To stop the appliance, press the ON
button and release.
Only MAS95..:
Soft start function
When the appliance is switched on, the
blade starts gently after a slight delay.
Only MAS95..:
Setting lower speed
The blade speed can be reduced, e.g.
for slicing cheese. If the appliance was
switched off, the blade will run at maximum
speed when the appliance is next switched
on.
■ Press cheese button 4. Lamp in the
button is lit.
■ To switch to the standard speed, press
the cheese button again. Lamp goes
out.
Slicing
■ Place the food which is to be sliced on
the carriage and gently push against the
stop plate.
■ Slowly slide the food which is to be
sliced against the moving blade.
12
MAS9xxxx_8001027218.indb 12
After using the appliance
■ Set the slicing width to 0.
■ Slide the carriage towards the blade
into the end position and lock with the
slide 8.
Notes:
■ Cut sausage and cheese first and bread
last. The appliance is then easier to
clean.
■ For reasons of hygiene, the appliance
and the blade should be cleaned
immediately after slicing greasy
food (e.g. meat, sausage, cheese).
X "Cleaning"
■ If required, clean the blade cover and
blade scraper X "Cleaning"
Cleaning
The appliance requires no maintenance!
Thorough cleaning guarantees a long
service life.
W Risk of electric shock!
Never immerse the appliance in water or
place under running water and do not clean
in the dishwasher.
W Risk of injury from sharp blade!
Before cleaning the appliance, pull out the
mains plug and remove the blade. Do not
grip the blade by the cutting surface, but by
the blade attachment.
Caution!
■ Surfaces may be damaged. Do not use
abrasive cleaning agents.
■ The appliance will not run without the
blade cover. After cleaning the blade,
attach the blade scraper and blade
cover.
Cleaning the appliance
■ Wipe the appliance, blade cover,
blade and blade scraper with a damp
cloth and dry. If required, use a little
detergent.
■ The blade scraper, "Sausage end"
holder and serving tray are dishwash-
er-proof. Do not wedge them in the
dishwasher as they could warp.
09.11.2015 14:30:44