BEFORE YOU BEGIN
This unit can be installed following these basic
steps:
- Cut out the countertop opening.
- Mount the downdraft in the cabinet.
- Install the blower and electrical panel.
- Connect the ductwork and electrical.
- Install the cooking appliance.
PREPARATION
FIGURE 1
Preparation of the cabinet:
Note: This downdraft can only be used
with electric cooktops. Refer to Figure 2 for
examples of typical installations.
For installations using one electric cooktop, the
maximum total element wattage is 9400 watts.
For installations using two electric cooktops, the
maximum total element wattage is 3400 watts.
Follow cooktop manufacturer's instructions to
prepare cabinet and countertop for cooktop
installation.
Determine the location of the downdraft(s) and
cut a 4-13/16" x 19-5/16" opening in countertop.
Please note: an electrical outlet will need to be
installed in the cabinet to supply the downdraft
control box with power. Refer to the section
titled "Wiring" for more information.
Examples of installation
FIGURE 2
DOWN
DOWN
DRAFTS
DRAFT
COOKTOP
COOKTOP
DUCT
WORK
ELECTRICAL BOX
BLOWER
BLOWERS
ELECTRICAL
BOXES
- 6 -