Remove packaging
IMPORTANT: Do not remove any permanent instruction
labels inside your ice machine or the Tech Sheet that is
fastened behind the lower access panel.
• Remove tape and any labels from your ice maker before
using (except the model and serial number label).
To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and dry.
About the controls and features.
POWER ON/OFF - Press to turn the ice machine on or off.
ICE MAKING -
Glows white when the unit is ON.
CHECK WATER -
Glows red when there is not water supplied to the machine.
TIME TO CLEAN - Glows yellow when it's time to clean the machine. The light will switch ON after 6 months of use. It will
remain on until the ice making system is cleaned using the process in the Care and cleaning section
CLEAN RESET -
Pressed with Power button for 5 seconds to start the cleaning process (see Care and Cleaning).
4
POWER
ICE
ON/OFF
MAKING
• Do not use sharp instruments, rubbing alcohol, flammable
fluids or abrasive cleaners to remove tape or glue. These
products can damage the surface of your ice maker. For
more information, see Important Safety Instructions
CLEAN
CHECK
TIME TO
RESET
WATER
CLEAN
.