Controls And Features; Remove Packaging; Important - GE Monogram ZDI15 Guía De Uso Y Cuidado

Remove
IMPORTANT: Do not remove any permanent
instruction labels inside your icemaker or the
packaging
Tech Sheet that is fastened behind the lower
access panel.
•
To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing
a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
Clean before
After you remove all of the packaging
materials, clean the inside of your icemaker
using
before using it.
Set controls
1. To start the normal ice making cycle,
2. To stop icemaker operation, select OFF.
10
Remove tape and any labels from your ice-
maker before using (except the model and
serial number label).
select ON.

Controls and Features

Icemaker
•
Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These
products can damage the surface of your
icemaker. For more information, see the
"Important Safety Instructions" sectio
See the cleaning instructions in the "Care and
Cleaning" section.
NOTE: The CLEAN setting is used whenever
solutions are circulated through the icemaker
for cleaning. Only the water pump operates at
this setting. See the "Care and Cleaning" section.
n.