Connecting the Headphone System
Setup
You can place the digital surround processor in an upright position or on its side.
To use in an upright position:
Use a coin to attach the supplied stand to the bottom of the digital surround
processor.
To use on its side:
Place the digital surround processor so that the four rubber supports are on the
bottom.
Notes
• Install the digital surround processor in a location where there are no obstructions between the
processor and headphones when used.
• Do not install the digital surround processor in unstable locations, such as on top of the TV. If
the processor falls down, it could cause an injury or be damaged.
• If the digital surround processor is placed in an upright position, always attach the stand for
added safety.
• If the digital surround processor is placed on its side, the full infrared transmission range may
not be obtained depending on installation conditions.
• If the digital surround processor is placed on its side, do not place the digital surround
processor on the side not having the rubber supports.
/
Rubber supports
(Continued)
GB
13
Operation