Machine´s Safety Equipment; General; Blade Guards; Engine On Off Switch - Husqvarna MS 360 G Manual De Instrucciones

General

WARNING! Never use a machine that has
!
faulty safety equipment! If your machine
fails any checks contact your service
agent to get it repaired.
Shut off the machine.
This section describes the machine ' s safety equipment,
its purpose, and how checks and maintenance should be
carried out to ensure that it operates correctly.

Blade guards

WARNING! Never use the machine
!
without a guard nor with a defective
guard. Always check that the guard is
correctly fitted before starting the
machine.
It is not permitted to expose the blade
more than 180 degrees without
protection.
The blade guard is designed to prevent parts of the blade
or cutting fragments from being thrown towards the user.
Check the blade guard
• Check that the guard over the blade is not cracked or
damaged in any other way. Replace when damaged.
MACHINE´S SAFETY EQUIPMENT

Engine ON OFF switch

Checking the engine OFF switch.
• Turn the engine start switch to OFF position.
• Check that the motor and the blade stop.
A defective engine start switch should be replaced by an
authorized service workshop.

Locking knob, conveyor cart

The locking knob is used to lock the conveyor cart in place
when in transit.
Checking the locking knob, conveyor cart
• Make sure the locking knob is in position and that the
conveyor cart is locked.

Water pump

WARNING! Do not run dry. The pump
!
may only be used together with the
products in this manual and shall be
used in accordance with the directions in
the manual.
–
English 7