Parallel To The Cutting Slot And Centered In The Cutting Slot; Fill With Coolant - Husqvarna MS 360 G Manual De Instrucciones

Parallel to the cutting slot and centered in
the cutting slot
• Set the blade to run freely and in its lowest position in
the cutting slot.
• Use an set square and check if the blade is
perpendicular, both front and back edge of the blade
to the conveyor cart anvil and check if the blade is
centered in the cutting slot.
• To adjust the blade, loosen the four screws holding the
support arm.
• Set the blade in the center of the cutting slot.
• Check again that the blade is perpendicular to the
conveyor cart anvil, the whole side of the blade must
be in contact with the set square. Tighten the four
screws holding the support arm.
12 – English
ASSEMBLING AND ADJUSTMENTS

Fill with coolant

Make sure the water level is always above the low walls
where the pump is located.