Installing Your Refrigerator - Impecca RC-2311 Manual De Usuario

INSTALLING YOUR REFRIGERATOR

UNPACKING YOUR REFRIGERATOR
1. Remove all packaging material. This includes the foam base
and all adhesive tape holding the refrigerator accessories
inside and outside.
2. Inspect and remove any remains of packing, tape or printed
materials before powering on the refrigerator.
I DANGER I
Risk of fire or explosion. Flammable refrigerant used. Handle with
care when moving refrigerator so to avoid damaging refrigerant
tubing or increasing the risk of leakage.
LEVELING YOUR REFRIGERATOR
• Your refrigerator has two leveling legs which are located in the
front bottom corners of your refrigerator. After properly placing
your refrigerator in its final position, you can level your refrig-
erator.
• Leveling legs can be adjusted by turning them counterclock-
wise to raise your refrigerator or by turning them clockwise to
lower your refrigerator. The refrigerator door will close easier
when the leveling legs are extended.
PROPER AIR CIRCULATION
• To ensure your refrigerator works at the maximum efficiency
it was designed for, you should install it in a location where
there is proper air circulation, plumbing and electrical connec-
tions.
• The following are recommended clearances around the refrig-
erator:
Sides ............... 4"
Top ............... 4"
Back ............... 4"
–12–