To Connect A Dust Extractor To The Product; To Start The Motor; To Operate The Product; To Connect The Product - Husqvarna Soff-Cut 150 E Manual Del Usuario

performance of the dust extractor can change over
time.
To connect a dust extractor to the
product
1. Turn the wing nut on the plug counterclockwise.
2. Remove the plug from the pipe on the blade block
cover.
3. Connect a dust extractor to the blade block.
Note: If the dust extractor is not compatible with the
connection on the product, use an adapter.

To connect the product

WARNING: Make sure that the electrical
supply align with the data on the rating plate.
WARNING: Make sure that the mains socket
is correctly grounded before you connect the
product. Refer to
instructions on page 6 .
1. Connect the product to a recommended extension
Recommended cable dimensions on
cable. Refer to
page 24 .
2. Connect the extension cable to a correctly grounded
Grounded product instructions on
outlet. Refer to
page 6 .
14
Grounded product

To start the motor

• Push the lock button (A) and pull the power switch
(B) up.

To operate the product

CAUTION: Make sure that no objects hit the
blade block. It can cause damage to the
product.
1. Start the motor. Refer to
14 .
2. Align the front pointer (A) and the rear pointer (B)
with the line where you will do the cut.
B
3. Push the handle down and pull the blade release
lever to slowly lower the blade into the concrete.
A
B
To start the motor on page
A
1038 - 002 - 17.10.2019