Assembling And Adjustments; General; Fitting The Blade; Handle Height - Husqvarna FS400 LV Manual De Instrucciones

ASSEMBLING AND ADJUSTMENTS

General

WARNING! Switch off the engine before
!
carrying out any checks or maintenance.
Check that the blade and the blade guard are
correctly fitted before starting the machine.

Fitting the blade

• Wind up the cutting depth feeding wheel.
• Switch off the water tap. Disconnect the water hose from
the blade guard.
• Loosen the front nut and tilt the blade guard to service
position.
WARNING! Check that the blade, blade flange
!
and blade shaft are undamaged. Clean the
contact surfaces of the blade and the blade
flange. Make sure the blade and the flanges
are clean and free of dirt and debris before
mounting the blade on the machine.
• Check the blade's direction of rotation. The arrow on the
blade indicates the direction of rotation.
• Fit the blade on the blade shaft (A). Fit the blade flange (B)
over the blade. Make sure that locking pin on flange (A)
passes through the blade and into the flange (B). Tighten
the screw (C) properly using the supplied spanner.
8 –
English
• Refit the blade guard and water hose in reverse order as
set out for dismantling.

Handle height

The height of the lever can be adjusted in height.
• Loosen the screw. Set handle to most comfortable
working height. Tighten the screw.

Cutting depth indicator

The indicator must be calibrated before it is taken into use.
• Wind down the blade so that it barely touches the ground.
• Loosen the screw. Position the indicator arrow to "0".
Tighten the screw.

Parking brake

Apply the parking brake.
N
N
P
P