Vermeiren Luna Manual De Instrucciones página 18

N
3.3.3 Wooden side railings
Assembly shown below applicable for types: Luna, Luna Basic, Luna Deluxe, Luna X-low.
Depending on your type of Luna bed, certain images might appear different.
Insert the short bolt rails (1) on the right and left in the upper wood slat. Insert the
A.
long bolt rails (2) right and left in the lower wood slat.
Insert the long bolt rails (2) in the wood slat in the sliding rail for the head and
foot section one by one and secure them by inserting the rails until the upper end is
inserted and clicks. On one side release this rail again until the tip by pressing the
position locking button (5) and pulling the upper wooden slat gently upwards.
Let the bolt rails (2) fall from the sliding rail once more until the tip of the rail is just
barely in the guide. The short bolt rail (1) will now be inserted together with the
wooden slat between the walls of the long bolt rails and the entire bolt rail system (1)
+ (2) will placed in the relevant sliding rail (4) by pulling upwards when grasping
only the upper wooden slat and then locking the structure in position.
Insert the locknuts (6) and tighten them manually.
B.
1 = Short bolt rails
2 = Long bolt rails
3 = Wood slats (2 pieces each side)
4 = Sliding rail
5 = Position locking button
6 = Locknut
Page 16
Luna
2010-11