Troubleshooting - ECOVACS ROBOTICS WINBOT X Manual De Instrucciones

Ocultar thumbs Ver también para WINBOT X:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

No.
Malfunction
Safety Pod Status Indicator
1
Light glows a continuous RED
WINBOT Status Indicator Light
2
glows a continuous RED
Possible Causes
The Safety Pod is not paired with WINBOT
(WINBOT arrives from the factory paired with
its Safety Pod. If the Safety Pod becomes
unpaired or is replaced, it can be re-paired).
Safety Pod is losing its suction.
Safety Pod is in Sleep Mode.
Safety Pod Jack is not connected with the
Safety Pod Port on WINBOT.
WINBOT has moved over a problem area and
is losing suction.
Edge Detection Sensor are dirty.

6. Troubleshooting

Solutions
Within the first 5 seconds of powering ON WINBOT, press
and hold the START/PAUSE Button on WINBOT and the
Pairing Button on the Safety Pod at the same time. Pairing
is complete when the Safety Pod Status Indicator Light
blinks RED and GREEN and beeps.
A. Press the Safety Pod firmly to see if the Safety Pod
Status Indicator Light glows a continuous GREEN within
5 seconds.
B. Take the Safety Pod off the window and use the
Finishing Cloth to wipe it clean, then repeat Solution A.
Power OFF the Safety Pod then power it ON again.
Insert the Safety Pod Jack into the port as described in
Section 3.2.
Press the RESET Button on the Remote Control and use
the Direction Control Buttons to move WINBOT away
(at least 10 cm/4") from the problem area. Then you can
either press the START/PAUSE Button to resume cleaning
in AUTO Cleaning Mode or use the Direction Control
Buttons to manually clean the area.
Wipe the Edge Detection Sensors clean as described
in Section 4.2. If the problem persists, please contact
Customer Service.
27
EN

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido