Messages On The Display; Optical Message; What To Do In The Event Of A Fault - Siemens TK 70 N 01 Instrucciones De Uso

If the descaling process is terminated,
the descaling alarm is not cancelled and the
appliance prompts the customer to carry out
a complete rinsing procedure according to the
instructions on the display.
If inadequate descaling solution or fresh
i
rinsing water was used, the appliance goes
back one step and the display prompts the
customer to add descaling solution or
water again.
Manually resetting the Needs to
be descaled display
If a manual descaling procedure is run,
the Needs to be descaled display can be
cancelled on display 5.
S
Hold down button
S
Select Descaling alarm reset? with button
P 4.
S
Select Yes with button
or button + 3.
S
Press button
descaled display is cancelled.
Important
The appliance must be descaled regularly,
otherwise it will be damaged.

Messages on the display

Ô Fill and Water flash alternately on display 5
S
The water tank 8 is empty.
Fill with fresh water.
However, one more cup can be drawn.
i
Important: If the appliance signals Fill and
Water even though the tank is full, see the
chapter on What to do in the event of
a fault".
Ô Empty and Capsules flash alternately
on display 5
S
The capsule container 15 is full.
Dispose of the used NESPRESSO
capsules (Fig. 6).
Ô Check and Container flash alternately
on display 5.
P 4 for three seconds.
- 2
1. The Needs to be
R
S
The drip tray 14 and capsule container 15
are missing.
Correctly insert the drip tray 14 and capsule
container 15.
Ô Power save lights up on display 5.
S
If the appliance is not used for one hour,
it automatically switches to power save
mode.

Optical message

Ô Float 16 rises.
During the rinsing process and when coffee is
being made, a little water runs into the drip
tray 14. When the tray is full, the float rises
(Fig. 6).
S
Pull the drip tray 14 forwards.
S
Remove the capsule container 15.
S
Empty the drip tray 14 and rinse with a little
detergent solution.
S
Place the capsule container 15 on the drip
tray 14 and re insert.
What to do in the event
of a fault?
The appliance is not functioning.
S
Check whether there has been a power
failure or the mains plug has been pulled out.
Hot water or steam cannot be drawn.
S
The nozzle 13 is blocked.
Clean the nozzle 13 with a detergent
solution and a blunt needle.
Milk froth is too little or too runny.
S
The CAPPUCCINO/CAFFELATTE frothing
device 12 is blocked.
Clean with a mild detergent solution
according to the instructions.
S
Use cold semi skimmed milk preferably.
en
21