xp CDR 800/00 eng.-1.1
18-07-2001 13:54
Installation
Analog connections
These connections are required for playback and recording via
an amplifier/receiver, equipped with an analog in- and outputs.
3
1
Connect supplied audio cable between the ANALOG
OUT-sockets on the set and the ANALOG input sockets of
the amplifier/receiver (TAPE IN, CD-R, AUX or PLAY IN).
Insert the red plugs into the R sockets, and the white plugs
into the L sockets.
2
Connect supplied audio cable between the ANALOG IN-
sockets on the set and the analog outputs of the
amplifier/receiver (CDR OUT,TAPE OUT, AUX OUT, REC
OUT etc.).
Insert the red plugs into the R sockets, and the white plugs
into the L sockets.
3
Connect all other components of your system (tape deck,
CD player, tuner, record player etc.) via their ANALOG
OUT-sockets to the appropriate analog input sockets of
the amplifier/receiver (CD IN,TUNER IN, AUX IN,
PHONO IN etc.).
Any analog device, connected to the amplifier/receiver
can now be used as recording source (AUX ANALOG).
10
Pagina 10
RECORD PLAYER
CD PLAYER
3
AMPLIFIER/
RECEIVER
1
2
CD RECORDER
Digital connections
Direct digital coaxial connection
This connection is required for direct recording from a digital
coaxial source (e.g a CD player, DVD, DAT).
3
1
Connect a digital coaxial cable between the DIGITAL IN-
socket on the set and the DIGITAL OUT socket of the
digital source.
Recording can now be done via the digital coaxial input
(AUX DIGITAL).
Direct digital optical connection
This connection is required for direct recording from a digital
optical source (e.g. a CD player, DVD, DAT).
2
CD RECORDER
1
Remove the dust caps from the digital optical connections
of both source and CD recorder. Keep the caps in a safe
place.
2
Connect an optical fibre-optic cable
between the OPTICAL IN socket of
the set and the OPTICAL OUT
socket of the source.
Make sure you insert both plugs
fully, until a click is heard.
Recording can now be done via the digital optical input
(AUX OPTICAL).
CD PLAYER
CD RECORDER
CD PLAYER
"click"