Descargar Imprimir esta página

Normas De Seguridad / Definiciones; Instrucciones Importantes De Seguridad - Stanley PI500PS Manual De Instruccion

Inversor eléctrico de 500 vatioscon puerto de carga usb

Publicidad

Idiomas disponibles

Idiomas disponibles

Common Power Output Problems
Input voltage below 10.5 volts
Recharge auto battery or check DC power supply.
Equipment being operated draws too much power
• Reduce load to maximum 500 watts if connected via battery clips.
• Reduce load to maximum 120 watts if connected via the 12V dc accessory plug.
• Connect directly to power source using the included Battery Clips when operating above 120 watts.
Inverter in thermal shutdown condition
Allow inverter to cool down. Ensure there is adequate ventilation around the unit and that the load does not exceed the
maximum wattage.
AC output is shorted
Unplug the AC appliance. Disconnect the unit from any 12 volt DC power source. Check the appliance cord.
The power/fault LED flashes red
When the Power/Fault LED Indicator turns from blue (indicating the unit is powered) to flashing red, a fault condition is present
and the unit will automatically shut down. See the Protective Features Section of this Instruction Manual and Common Power
Output Problems in the previous section.
ACCESSORIES
Recommended accessories for use with this unit may be available from the manufacturer. If you need assistance regarding
accessories, please contact manufacturer at 1-877-571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at 1-877-571-2391.
FULL ONE-YEAR WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the
date of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired
in the following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer's option. Proof
of purchase may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an
exchange (provided that the store is a participating retailer). Returns to retailer should be made within the time period of the
retailer's return policy for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check
with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects resulting from normal wear and tear, accidents;
damages sustained during shipping; alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state
to state or province to province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from purchase of the product to: Baccus Global LLC,
595 S. Federal Highway, Suite 210, Boca Raton, FL 33432. Baccus Global LLC, toll-free number: 1-877-571-2391.
SPECIFICATIONS
Maximum Continuous Power:
500 watts
Input Voltage:
12.5 volts DC, 48 amps
Output Voltage:
Approx. 110-125 volts AC RMS, 60 Hz
Wave Form:
Modified Sine Wave (MSW)
Output Connection:
North American Standard Receptacles
USB Output:
5 V DC (2A)
DC plug fuse:
12A/250V
Imported by Baccus Global LLC, 595 S. Federal Highway, Suite 210, Boca Raton, FL 33432 • (877) 571-2391
PI500PS_ManualENSP_053014.indd 10-11
RD053014
10

NORMAS DE SEGURIDAD / DEFINICIONES

PELIGRO: Indica una situación de peligro inminente que, si no se evita, provocará la muerte o lesiones graves.
ADVERTENCIA: Indica una situación de peligro inminente que, si no se evita, provocará la muerte o lesiones graves.
PRECAUCIÓN: Indica una situación de peligro potencial que, si no se evita, puede provocar lesiones leves o moderadas.
PRECAUCIÓN: Utilizado sin el símbolo de alerta de seguridad indica una situación de peligro potencial que, si no se evita, puede
provocar daños a la propiedad.
RIESGO DE OPERACIÓN INSEGURA. Cuando se utilizan herramientas o equipos, siempre se deben respetar las precauciones
de seguridad para reducir el riesgo de lesiones personales. La operación, el mantenimiento o la modificación incorrectos de
herramientas o equipos pueden provocar lesiones graves y daños a la propiedad. Las herramientas y los equipos están diseñados
para usos determinados. Fabricante recomienda encarecidamente que NO se modifique este producto y que NO se utilice para
ningún otro uso que aquél para el que fue diseñado. Lea y comprenda todas las instrucciones operativas y las advertencias
antes de utilizar cualquier herramienta o equipo.

INSTRUCCIONES IMPORTANTES DE SEGURIDAD

ADVERTENCIA: Este producto o su cable de alimentación contiene plomo, una sustancia química reconocida por el Estado
de California como causante de cáncer, defectos de nacimiento u otros problemas reproductivos. Lávese las manos después de
utilizarlo.
LEA TODAS LAS INSTRUCCIONES
ADVERTENCIA: Lea todas las instrucciones antes de operar el inversor eléctrico. El incumplimiento de todas las
instrucciones enumeradas a continuación puede provocar una descarga eléctrica, un incendio o lesiones graves.
ADVERTENCIAS E INSTRUCCIONES DE SEGURIDAD GENERALES
• Evite las condiciones ambientales peligrosas. No utilice el inversor en zonas húmedas o mojadas. No utilice el inversor bajo
la lluvia.
• Guarde los artefactos que no utilice en el interior. Cuando no los utilice, los artefactos deben guardarse en el interior en un
lugar seco, alto o bajo llave, lejos del alcance de los niños.
• No utilice el inversor para cualquier tarea que no fue diseñado para hacer.
• Desconecte el inversor. Desconecte el inversor de la fuente de energía cuando no lo utiliza.
• El enfriamiento correcto es fundamental al operar el inversor. No coloque la unidad cerca de los orificios de ventilación del
vehículo ni la exponga a la luz solar directa.
• Uso de suplementos y accesorios. El uso de accesorios o dispositivos no recomendados para este aparato puede resultar
peligroso. Nota: consulte la sección "accesorios" de este manual para obtener detalles adicionales.
• Verifique que no haya piezas dañadas. Cualquier parte que esté dañada se debe reparar o reemplazado por el fabricante.
ADVERTENCIA: PARA REDUCIR EL RIESGO DE DESCARGA ELÉCTRICA:
• NO conecte al cableado de distribución de CA.
• NO realice conexiones o desconexiones eléctricas en áreas designadas como PROTEGIDAS CONTRA IGNICIÓN. Esto incluye
el adaptador para aviones o el enchufe tipo encendedor de cigarrillos de CC. Esta unidad NO está aprobada para áreas
protegidas contra ignición.
• NUNCA sumerja la unidad en el agua ni en ningún otro líquido, ni la utilice cuando esté húmeda.
• NO introduzca objetos extraños en los tomacorrientes de CA del inversor o puerto de carga USB.
ADVERTENCIA: PARA REDUCIR EL RIESGO DE INCENDIO:
• No opere cerca de materiales, vapores o gases inflamables.
• NO lo exponga al calor extremo o a llamas.
PRECAUCIÓN: PARA REDUCIR EL RIESGO DE LESIONES O DAÑO A LA PROPIEDAD:
• Desconecte el enchufe del tomacorriente antes de trabajar en el artefacto.
• NO intente conectar o configurar la unidad o sus componentes mientras maneja su vehículo. El hecho de no prestar atención a
la carretera puede tener como consecuencia un accidente grave.
• Siempre utilice el inversor en lugares adecuadamente ventilados. No bloquee las ranuras de
ventilación.
• SIEMPRE APAGUE el inversor desenchufándolo del tomacorriente para accesorios de CC cuando no lo utilice.
• Asegúrese de que el voltaje nominal de encendido sea CC de 12 voltios, conexión central positivo (+).
• Al utilizar esta unidad en un vehículo, revise el manual del usuario del vehículo para ver el máximo rango de potencia y la
salida recomendada. No lo instale en el compartimiento del motor. Instálelo en un área bien ventilada.
• NO lo utilice con sistemas eléctricos con positivo a tierra*. La conexión de polaridad inversa hará que el fusible se queme y
puede causar un daño permanente al inversor y anulará la garantía.
*La mayoría de automóviles, vehículos recreativos y camiones modernos posee un negativo a tierra.
• Tenga en cuenta que este inversor no funcionará con aparatos o equipos de alta potencia en vatios que produzcan calor, como
secadores de cabello, hornos de microondas y tostadores.
11
5/30/2014 10:17:33 AM

Publicidad

loading