Descargar Imprimir esta página

Advertencias E Instrucciones De Seguridad Generales; Lea Las Instrucciones; Normas De Seguridad / Definiciones; Instrucciones Importantes De Seguridad - Stanley PCA120 Manual De Instruccion

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLEShOOTINg
Common Audio problems
buzzing Sound In Audio Systems
Some inexpensive stereo systems and boom boxes make a buzzing sound when operated from the inverter, because the power
supply in the electronic device does not properly filter the modified sine wave produced by the inverter. The only solution to this
problem is to use a sound system that has a higher quality power supply.
Common power Output problems
Input voltage below 10.5 volts
Recharge auto battery or check DC power supply.
Equipment being operated draws too much power
Reduce load to maximum 120 watts for 60 minutes and 100 watts continuous.
Inverter in thermal shutdown condition
Allow inverter to cool down. Ensure there is adequate ventilation around the unit and that the load is no more than 100 watts for
continuous operation.
AC output is shorted
Unplug the AC appliance. Disconnect the unit from any 12 volt DC power source. Check the appliance cord.
ACCESSORIES
Recommended accessories for use with your tool are available from the manufacturer. If you need assistance regarding accessories,
please contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INfORmATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
ONE-yEAR LImITED wARRANTy
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the date
of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired in the
following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer' s option. Proof of purchase
may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an exchange (provided
that the store is a participating retailer). Returns to retailer should be made within the time period of the retailer' s return policy
for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their
specific return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs, fuses and batteries; defects resulting from normal wear and tear, accidents;
damages sustained during shipping; alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to
state or province to province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from purchase of the product to: baccus Global LLC,
toll-free number: 1-877-571-2391.
SpECIfICATIONS
DC input:
13.8 volts DC, 8 amps
AC output:
110-125 volts AC, 60hz, 120 watts for 60 minutes and 100 watts continuous
Output waveform:
Modified Sine Wave
USB charging:
5 volts DC, 1,000 mA
DC plug fuse:
12A/250V
Imported by
Baccus Global LLC
595 S. Federal highway, Suite 210
Boca Raton, FL 33432
(877) 571-2391
PCA120_ManualENSP_060413.indd 6-7
RD060413
6

ADVERTENCIAS E INSTRUCCIONES DE SEGURIDAD GENERALES

LEA LAS INSTRUCCIONES

ADvERTENCIA: Lea todas las instrucciones antes de operar el inversor . El incumplimiento de todas las instrucciones
enumeradas a continuación puede provocar una descarga eléctrica, un incendio o lesiones graves.

NORmAS DE SEgURIDAD / DEfINICIONES

PELIGRO: Indica una situación de peligro inminente que, si no se evita, provocará la muerte o lesiones graves.
ADvERTENCIA: Indica una situación de peligro inminente que, si no se evita, provocará la muerte o lesiones graves.
PRECAUCIÓN: Indica una situación de peligro potencial que, si no se evita, puede provocar lesiones leves o moderadas.
PRECAUCIÓN: Utilizado sin el símbolo de alerta de seguridad indica una situación de peligro potencial que, si no se evita, puede
provocar daños a la propiedad.
RIESGO DE OPERACIÓN INSEGURA. Cuando se utilizan herramientas o equipos, siempre se deben respetar las precauciones
de seguridad para reducir el riesgo de lesiones personales. La operación, el mantenimiento o la modificación incorrectos de
herramientas o equipos pueden provocar lesiones graves y daños a la propiedad. Las herramientas y los equipos están diseñados
para determinados usos. Fabricante recomienda encarecidamente que NO se modifique este producto y que NO se utilice para
ningún otro uso que aquél para el que fue diseñado. Lea y comprenda todas las instrucciones operativas y las advertencias antes de
utilizar cualquier herramienta o equipo.

INSTRUCCIONES ImpORTANTES DE SEgURIDAD

• Evite las condiciones ambientales peligrosas. No utilice artefactos en zonas húmedas o mojadas. No utilice artefactos bajo
la lluvia.
• Mantenga a los niños ausentes. Guarde lejos de niños. ¡Esto no es un juguete!
• Guarde los artefactos que no utilice en el interior. Cuando no los utilice, los artefactos deben guardarse en el interior en un
lugar seco, alto o bajo llave, lejos del alcance de los niños.
• Desconecte los aparatos. Desconecte el aparato de la fuente de energía cuando no lo utiliza.
• El enfriamiento correcto es fundamental al operar el inversor . No coloque la unidad cerca de los orificios de ventilación del
vehículo ni la exponga a la luz solar directa.
• Uso de suplementos y accesorios. El uso de accesorios o dispositivos no recomendados para este aparato puede resultar
peligroso.
• Manténgase alerta. Use el sentido común. No haga funcionar el inversor cuando está cansado.
• Compruebe para saber si hay piezas dañadas. Una pieza que esté dañada debe ser reparada o sustituida por el fabricante
antes de su uso posterior a menos que se indique lo contrario en este manual de instrucciones.
• No opere herramientas eléctricas portátiles cerca de líquidos inflamables o en atmósferas gaseosas o explosivas. Los motores de
estas herramientas normalmente chispean, y las chispas pueden encender los vapores.
ADvERTENCIA: PARA REDUCIR EL RIESGO DE DESCARGA ELÉCTRICA:
• Realice las conexiones o desconexiones en las áreas designadas como protegidas contra ignición. Esto incluye enchufe tipo
encendedor de cigarrillos del DC. Esta unidad no está aprobada para áreas protegidas contra ignición.
• Nunca sumerja la unidad al agua ni en ningún otro líquido, ni la utilice cuando esté húmeda.
• No inserte los objetos extranjeros en los enchufes del inversor .
ADvERTENCIA: PARA REDUCIR EL RIESGO DE INCENDIO:
• No reemplace cualquier fusible del vehículo con uno de una calificación superior a la recomendada por el fabricante del vehículo.
Este producto se clasifica para extraer 8 amperios de un enchufe del accesorio del vehículo de 13.8 voltios. Asegúrese de que
el sistema eléctrico en su vehículo pueda suministrar esto sin hacer el fusible del vehículo abrirse. Esto puede ser determinado
cerciorándose de que el fusible en el vehículo que protege el enchufe se clasifica más arriba de 8 amperios. La información sobre
los grados del fusible del vehículo se encuentra típicamente en el manual del operador del vehículo.
• Si el fusible del vehículo se abre en varias ocasiones, no lo siga reemplazando. Deje de utilizar el accesorio de 12v en el vehículo
y localice el origen de la sobrecarga. NUNCA remiende el fusible con la hoja de lata, alambre, o los similares, como esto puede
causar daño grave a otra parte en el circuito eléctrico o causar un fuego.
• No opere cerca de materiales, vapores o gases inflamables.
• NO lo exponga al calor extremo o a llamas.
• Cerciórese de que el enchufe de 12 voltios está libre de la ruina y el inversor cabe firmemente en el enchufe.
Ninguno de estos acciones pueden causar daño eléctrico serio y/o un fuego.
PRECAUCIÓN: PARA REDUCIR EL RIESGO DE LESIONES O DAÑO A LA PROPIEDAD:
• Desconecte el enchufe del tomacorriente antes de trabajar en el artefacto.
• No intente conectar o configurar la unidad o sus componentes mientras maneja su vehículo. El hecho de no prestar atención a la
carretera puede tener como consecuencia un accidente grave.
7
6/4/2013 10:48:38 AM

Publicidad

loading