Four-Wire Power Cord - LG DLE3500 Serie Manual Del Propietário

22 INSTALLATION

Four-Wire Power Cord

• A 4-wire connection is required for
all mobile and manufactured home
installations, as well as all new
construction after January 1, 1996.
• A UL-listed strain relief is required.
• Use a 30-amp, 240-volt, 4-wire,
UL-listed power cord with #10 AWG-
minimum copper conductor and closed
loop or forked terminals with upturned
ends.
1
Remove the terminal block access cover on the
upper back of the dryer.
2
Install a UL-listed strain relief into the power
cord through-hole.
3
Thread a 30-amp, 240-volt, 4-wire, UL-listed
power cord with #10 AWG-minimum copper
conductor through the strain relief.
UL-Listed 4-Wire Power
Cord
4
Transfer the dryer's ground wire from behind the
green ground screw to the center screw of the
terminal block.
5
Attach the two hot leads of the power cord to the
outer terminal block screws.
6
Attach the white neutral wire to the center screw
of the terminal block.
7
Attach the power cord ground wire to the green
ground screw.
8
9
Ground Screw
Power Cord Ground
Wire
Terminal Block
UL-Listed Strain Relief
Tighten all screws securely.
Reinstall the terminal block access cover.
Hot (Black) Neutral (White)
Hot (Red)
White Wire moved from
Ground Screw